Vestil HIPM series - Manual

1
VESTIL MANUFACTURING CORPORATION
2999 North Wayne Street
Angola, Indiana 46703 USA
Phone (260) 665-7586 Fax (260) 665-1339
E-mail: [email protected] • www.vestil.com
WARNINGS & SAFETY INSTRUCTIONS
Read owner's manual completely before operating unit!
• Not a personnel lift.
• Never go under forks if there is weight on unit.
• Remove weight & disconnect power before working on
unit.
• Use only maintenance parts supplied or approved by the
manufacturer.
• Do not change pressure relief valve setting.
• Do not clamp hydraulic cylinder in a vise as you may
distort the barrel.
• Never operate the lift unless you are watching it.
• Do not go near leaks - High pressure oil easily punctures
skin causing serious injury, gangrene, or death.
• Load tight agianst the bulkhead within the rated capcity.
• Transport loads in the lowered position only.
• Do not continue to operate the UP control if unit is not
raising.
• Relieve system pressure by operating the DOWN control
after the unit has come to rest.
• Consult factory before adding or performing any
modification to the original equipment.
• Do not use brake fluids or jack oils. Use AW-32 Hydraulic
oil or equal.
• Make sure all operator safety labels and guards are
in place.
RECEIVING INSTRUCTIONS
Every unit is thoroughly tested and inspected prior
to shipment. However, it is possible that the unit may incur
OWNER'S
MANUAL
HIGH RISE LIFT • MODEL HIPM
Revised 09-03 15-126-101
A company dedicated to solving ergonomic and material
handling problems since 1955.
HIGH RISE LIFT
MODEL HIPM
Contents
Warnings and Safety Instructions .......................... 1
Receiving Instructions ............................................ 1
Loading Instructions ............................................... 2
Operating Instructions ............................................ 2
Electric Schematic ................................................. 3
Battery Charger Operation .................................. 4-5
Hydraulic Operation and Schematic .................... 6-7
Trouble Shooting Guide ...................................... 8-9 Exploded Parts Drawing ...................................... 10
Parts Identification ............................................... 11
Periodic Maintenance Instructions ....................... 12
Foot Pump Operation ........................................... 13
Warning Label Identification ................................. 14
Warranty .............................................................. 15
damage during transit. If you see damage when unloading
make a note of it on the SHIPPER RECEIVER.
Remove all packing and strapping material, inspect
for damage. IF DAMAGE IS EVIDENT, FILE A CLAIM
WITH THE CARRIER IMMEDIATLY! Also, check the unit
size, type of power unit, etc., to ensure the unit is correct
for the intended application.
SERIAL NUMBER AND CAPACITY
The serial number and capacity is inscribed on the
nameplate (See p. 14 for location). Please remember to
include these numbers in any correspondence with your dealer
or the factory.