Vestil HIPM series - Manual (Page 2)

2
LOADING INSTRUCTIONS
The load capacity rating as inscribed on the
nameplate of your unit designates the net capacity
for an evenly distributed load. This capacity must
never be exceeded, as permanent damage or
injury may result.
When loading the lift always follow these guide-
lines:
1.) Always load tightly agianst the bulkhead.
2.) Transport loads in the lowered position only.
OPERATING INSTRUCTIONS
The High Rise Lift is furnished with a con-
stant pressure rocker switch control as standard
equipment.
In order to operate the unit, pressure must
be maintained in the UP or Down position to raise
or lower the forks. On releasing either button, the
forks will remain in that particular position until the
switch is depressed again.
Responsibilities of Owners/Users
It is the responsibility of the owner/user for
the following:
1.) The lift must be inspected and maintained in
accordance with the guidelines in this
manual.
2.) Any lift not in safe operating condition must
be removed from service until it is returned
to proper operating condition.
Unsafe condition may include, but is not
limited to the following : excessive hydraulic or air
leakage, missing rollers, pins, or fasteners, any
cracked or deformed structural members, cut or
frayed hydraulic, electric or air lines, and dam-
aged controls or safety devices.
All repairs and maintenance must be per-
formed by qualified personnel.
3.) Lift may only be used be used by authorized
personnel. All lift operators must have read
and understood all operating procedures
and safety guidelines in this Owner's Manual.
4.) Lift must never be overloaded.
5.) Operator must ensure that all safety
features of the lift are functioning properly
before each use.
6.) Any modifications to the lift must be
approved in writing by the manufacturer.
ORDERING REPLACEMENT OR EXTRA PARTS
Our company takes pride in using the finest
available parts for our equipment. We are not
responsible for equipment failure resulting from the
use of unapproved replacement parts. To order
replacement or extra parts for your equipment
contact Customer Service at the factory. In any
correspondence with the factory please include the
Serial Number which is inscribed on the nameplate
of the piece of equipment. Use only the part
numbers provided in this Owner's Manual. When
ordering parts for AC power units please indicate
the motor phase and voltage that the equipment is
operating on.