Vestil SCALE-S User Manual
Page 7
7
3
Installation and connection
3.1 Installation method
There are 3 installation method for LP7510
1． Wall mounting: Use screw M5 to fix the base of the weighing
display to the wall
2． Table mounting：Adjust the elevation of the weighing display
and the base. And then put it on the table.
3． Column mounting：Take off the base, then use screw M8 to fix
the feet to the column
3.2 Connection
3.2.1 Supply power connection
2 kinds of power supply : One is AC 100-240V; another is in-built
storage battery DC supply power, with charger.
AC powered connection method:
1. Open the back cover of the weighing display. And take off the
Water-proof connector with AC mark. And insert the equipped power
Line insider the back cover.
2. Fix the 3 core line to 5 bit terminal block J1 on the back cover AC
power board. Shown as the below picture.
J1 pin
Pin symbol
AC supply power
1
GND
Power ground line（yellow）
2
L
Power fire line（brown）
3
N
Power zero line（blue）
PDF 文件使用 "pdfFactory" 试用版本创建