Vortexx RMV Series - Manual (Page 10)

First Choice When Quality Matters
NORTH
AMERICA
Plunger Pumps
Operating Instructions and Parts Manual
RMV Series Pumps
many factors. Water seals should be
replaced when water leak or a loss
of performance is noticed. Prompt
replacement of worn seals will insure
peak operating performance and
trouble free operation. The water
seals and their respective components
sometimes referred to as the packing
stack, will vary slightly between
models. But the constant between
models is that the packing stack will
consist of the following items:
Piston Guides - which usually house
the low-pressure seal
Low-Pressure Seals
Piston Guide O-rings
High-Pressure Seals
Support Rings
Torque Ratings Inch Pounds
(ft.lbs.)
Head 221 (19)
Valve Cap 221 (19)
Oil - AR64545 - Container is 4.5 fluid
ounces. Specially formulated for the
demands of the 5XA48 pump. See
parts breakdown.
NOTE: No other oil is factory approved
for this pump. Using any other oil
may result in Drive End Damage.
Winter or Long Time Storage
1. Drain all of the water out of the
pump.
2. Run a 50% solution of a RV or
non-toxic/biodegradable antifreeze
through the pump.
3. Flush the pump with fresh water
before the next use.
4. In freezing conditions failure to
do this may cause internal pump
damage.
5. For long periods of storage in non-
freezing areas the solution will keep
the seals and O-rings lubricated.