Warner Electric CBC-1550AHFC - Manual (Page 21)

21 Warner Electric • 800-825-9050 819-9050
This completes all the programming of the Warner Electric control.
Common Terminology
1. Home position. – Long arm is straight and both paddles are inside the pusher enclosure.
2. Home reference. – Position of the pusher’s arm when the “ref” indicator on the display is illuminated.
3. Move preset. – Number of pulses that the control is going to count in each cycle. For this application it is
600 pulses.
4. Early Warning. – A distance prior to Move Preset at which the early warning output is activated. The early
warning is not used in Revision A or Revision B.
5. Count. – The actual “move distance” in pulses. This parameter changes from 0 to 600 when the pusher is
cycling.
6. Test number 8. – In the programming options, there is a “test number 8” in line 35. This test will erase all
the parameters in the control and will set everything to factory set. Factory set is not the program that the
pusher requires. If “test #8” is activated by accident, repeat all the programming steps in this document.
Torque Adjustments
1. Open the Warner Electric control.
2. Locate the CBC500 driver board on the CBC1550AHFC; or locate the CBC550 on the CBC1550AHFC.
3. Locate two small potentiometers near the indicator lights.
4. Adjust the torque on the brake or clutch via these potentiometers.
Note: I f t or que adj ust ment s ar e made af t er pr ogr ammi ng, r epeat pr ogr ammi ng sequence
st ar t i ng on st ep #52.
How to reset the program defaults:
If program is all messed up: (cc = 1.000 for instance ) step 18
Action Result Should See Comment
1. Press the “RUN/PGM” key.
Loc. 0
Opens program
2. Press 1, 0, 0, 0
Loc. 1000
3. Press and hold arrow down key until T8 is displayed.
t8. rdy
This is the very last step in
the program.
4. Press the arrow right key it will flash
t8. run
Program settings defaulted now.
5. Press the “RUN/PGM” key.
0
Unit is ready for reprogramming.
6. Unit must now be reprogrammed. Go to step 10.
Steps 10 thru 51.