Warner Electric PCBC-1525_1225 - Manual (Page 11)

11 Warner Electric • 800-825-9050 P-214 • 819-0518
Note: The 1225 and 1525 units are mounted
with four drive pins instead of three as shown in
the pictures; however, the assembly procedure
is the same for either case.
Step 1
Place straight springs (white) over armature boss-
es on back side of armature. (Figure 7)
Step 2
Compress the heavy (red) spring on each drive pin
by sliding detent spring towards head of pin.
(Figure 8)
Step 3
Insert assembled drive pins through armature
(entering from segmented side), through straight
(white) springs, and into magnet hub.
Note: Apply Grade "AA" Loctite ® Sealant on pin
threads. (Figure 9)
Step 4
Tighten pins until shoulders of pins are against
face of hub. Since threads are class No. 3 fit, pins
may seem to bind.
The straight springs must not
get caught under shoulders of drive pins.
Step 5
Check to see that the armature is completely
compressed against the face of the hub.
Step 6
To set the autogap, slide the detent spring retain-
ers against the armature face.
Note: This position must not be disturbed dur-
ing completion of assembly. (Figure 10)
Figure 7
Figure 8
Figure 9
Figure 10