Waterstone BRIDGE FAUCETS 6350 - Manual (Page 4)

COMPASS HOT AND COLD
FINISH MATCH
LEVER HANDLE CROSS HANDLE LEVER HANDLE
COUNTER
OR SINK
E
F
G A
C
B
D
1. 2. 3. 4.
4. Connect and tighten end
of sidespray hose to sidespray
hose tube. Check for leaks. 3. Remove hose cap (E) from
end of sidespray hose tube (F)
on faucet (G).
CONNECTING OPTIONAL SIDE SPRAY
1. Insert side spray base (A) into
side spray hole on your sink or
counter. No plumbers putty is
required. O-ring seals base. Slide
washer (B), thread attaching nut
(C) and securely tighten.
2. Slide sidespray hose (D)
through side spray base.
OPTIONAL DECORATIVE CAPS
1. Place a small standard
screwdriver in slot at bottom
of metal ring that surrounds
handle caps. Gently pry
button from faucet handle.
2. Position cap and snap in
with thumb.
1. Gently unscrew and remove spout tip (A) by hand.
2. Remove O-ring (B). To remove aerator (C), push with finger from bottom.
3. Thoroughly rinse aerator with water until all debris is removed.
4. Place aerator, then O-ring back into spout tip.
5. Gently screw spout tip, by hand, snuggly back onto spout. Depending on quality of your household water, the aerator
and debris screen may become clogged. We recommend
cleaning one week after installation, then a minimum of
once of year thereafter. To remove the debris, follow the
steps below.
CLEANING AERATOR AND DEBRIS SCREEN
B
C
A
1. 2. 3. 4. 5.