Seite6, Serial control input, rs 232, Switching to playback of a video recorder – WolfVision VZ-5B User Manual

Page 6: Not included with vz-5b)

Advertising
background image

Serial control input, RS 232

(not included with VZ-5b)

9-pin D-Sub connector on unit
male, front side

Pins: 2: RX, 3: TX, 5: GND, 7: RTS, 8: CTS
Baud rate: 19200, databits: 8, stopbit: 1, parity: no

5

9

2

7

3 4

8

1

6

The serial port can be used to control the Visualizer through an external device, like a
remote control system for a whole conferencing room.

Please note that DecimaI-Codes (=ASCII-Codes
or Hex-Codes) must be sent as one single byte
(e.g. 199 and not: 1 + 1 + 9) !

Between sending codes should be a break of
250ms minimum !

Switching to playback of a video recorder

WolfVision Visualizers do not have an input switch because the following method of
connecting a video recorder is much easier and requires no switching at all:

Connect the video output (12) or the Y/C (S-VHS) output (13) of the Visualizer to the
according input of the video recorder. Connect the video or Y/C (S-VHS) output of the
video recorder with the input of your monitor or video projector.

When the video recorder is switched to "Play", the picture of the video recorder
is shown (without any separate switching):

It can also be used to control the Visualizer through a computer. A special Windows-
software for PC is available from WolfVision.

(detailed description of serial
protocol available on request)

Function: Decimal-Code :
Image on 192
Iris open 193
Focus far 194
Zoom wide 195
Image off 196
Iris close 197
Focus near 198
Zoom tele 199
Preset 1 202
Preset 2 203
Save Preset 1 216
Save Preset 2 217
Preset max. wide 229
Preset A5 231
Preset A6 232
Preset max. tele 235

video

out

video

out

video

out

video

out

video

in

video

in

video

in

video

in

Position: "Stop"

Position: "Play"

Visualizer picture:

video recorder picture:

Adjust the video recorder so that the picture of the Visualizer will be shown
(Make sure that the input switch of the video recorder is in the right position.
If the video recorder has a TV-tuner switch to channel "0" or "AV"):

When the video recorder is switched to "Stop" again, the picture of the visualizer
reappears (without separate switching).

Advertising
This manual is related to the following products: