WolfVision VZ-35 - Manual (Page 17)

17
C.TEMP (Color temperature)
3200 K: for indoor shooting (Visualizer light etc.)
5600 K: for outdoor shooting (sunlight)
M.PED (master pedestal)
Normally set this to +00.
When the black parts of the picture are too dull, you can make them look sharp by adjusting the master
black level. Using a waveform monitor will make the adjustment easier.
DTL (detail)
You can use the DTL function to adjust the sharpness/the outlines of objects in the reproduced picture.
A higher set value makes the picture look sharper with more detail on the image outlines, and a lower
value makes the picture look softer with less detail.
GAMMA (gamma compensation)
ON: for normal use of the camera. The image reproduction characteristics of the monitor CRT are
properly compensated automatically to give pictures of natural tones.
OFF: for producing pictures convenient for image processing or image analysis. The video signal is
output linearly from the CCD without gamma compensation.
G.SYNC (Sync on green) - for RGBS output
ON: for using an RGB video monitor or video projector without separate sync input connector.
If set to ON the sync signal is added to the Green-signal output by the RGBS connectors (#40)
MAKE SURE THAT NO SEPARATE SYNC CABLE IS CONNECTED IF THE SYNC ON
GREEN FUNCTION IS ACTIVATED (The result would be a picture with too much green).
OFF: the G signal is output from the RGBS output without sync signal.
FLD/FRM (field/frame)
FLD: for shooting fast moving subjects. The CCD accumulates and outputs the charges field by field
to give pictures showing a minimum blur even when the subject is fast moving.
FRM: for producing pictures with the highest possible vertical resolution. The CCD accumulates and
outputs the charges frame by frame. Select this setting when using the camera with measuring
instruments, image processing or image analysis systems equipped with a frame memory or
still image processing systems.
Color bar signal:
When the Bars key is pressed while the menu function is switched off color bars appear on the
monitors connected to the Visualizer. These color bars can be used for adjusting the colors on a video
projector or monitor.
The color bars can be switched off again
by pressing the Bars key again. color
bars
display
bars
or