WolfVision VZ-35 - Manual (Page 7)

REFLECTIONS / GLARE
IMPORTANT
Reflections can appear only in the bottom half of the working surface, where the light is reflected directly into the
camera. In this case, move the object upwards and tilt the reflector head slightly.
If this is not possbile (e.g. with very big objects), pull the working plate to the front of the unit (as shown below)
and tilt the reflector head accordingly. As the working plate is magnetic, it will stick to the unit.
Reflection: No reflection: No reflection:
Working plate (#5)
Light reflected directly
into camera Light reflected to
the outside Light reflected to
the outside
Please make sure that reflections are not caused by room light !
LIGHTING
The lighting system is fixed for working on the working surface. Because of the oblique mounting of the
camera and the light projector of the Visualizer the light-field shifts to the left when the distance between the
Visualizer and the scanned object is increased. This means that the light field no longer exactly shows the
recorded area. The edges of the light field may also be unsharp. In this case switch off the Visualizers light
with the LIGHT off key (#23) and work with room light.
PRESET FUNCTION
PRESET 2 1
The Wolfvision Visualizer VZ-35 offers the possibility of programming two presets for the functions Zoom,
Focus, Iris, Light and Image. They can be recalled with the PRESET 1 (#25) and PRESET 2 (#26) key.
This function is very useful for example if a user requires one preset for papers on the working surface and
one preset for an object placed in front of the unit. During his presentation the user just has to press the
PRESET 1 or PRESET 2 key when he changes from one object to the other.
While the VZ-35 is adjusting the preset position the green LED light (#28) is flashing.
For programming a preset just adjust Zoom, Focus, Iris, Light and Image as required and simultaneously
press the PRESET 1 or the PRESET 2 key together with the Save key (camera controls, #12)).
PLEASE NOTE: Always press the Save key before the PRESET key!
Factory setup:
When using the POWER on key (#28) the unit is adjusting the "Factory Setup" (=Zoom and Focus on an A5
format on the working surface)
Save Save Preset 1 Preset 2 + + or:
7