Extron Electronics SSP 7.1 User Guide - Manual (Page 19)

Setup
This section provides background information about arranging speakers in a room and about
some of the settings that can be adjusted by the SSP 7.1 Setup and Control Software. Extron
strongly recommends that the control software is used to make any configuration changes
to the SSP 7.1. (See
“Setup and Control Software” on page 22).
z Speaker Setup
z
Bass Management
z Speaker Delay Settings
z Test Signals
z
Output Channel Trim Settings
z Listening Mode Settings
z Dynamic Range Compression Control
z Tone Controls
z
Volume Output
z Equalization
Speaker Setup
The following figures show the recommended speaker placement, relative to the listener, for
a five, six, or seven speaker system and for subwoofer placement.
NOTE: All speakers should be angled inwards so that they face towards the listener.
0°
22°
30°
90°
110°
C R L
RS LS
Figure 6. Five Speaker Setup
For an explanation of speaker abbreviations , see page 14.
SSP 7.1 • Setup 13