IEI Integration PICOe-PV-D4251_N4551_D5251 v1.00 - Manual (Page 54)

PICOe-PV-D4251/N4551/D5251 User Manual
Page 40
o Mouse
o RS-232 serial communications device
o USB devices
4.3 Unpacking
When the PICOe-PV-D4251/N4551/D5251 is unpacked, please check all the unpacking
list items listed in Chapter 3 are indeed present. If any of the unpacking list items are not
available please contact the PICOe-PV-D4251/N4551/D5251 vendor reseller/vendor
where the PICOe-PV-D4251/N4551/D5251 was purchased or contact an IEI sales
representative.
4.4 SO-DIMM and CF Card Installation
4.4.1 SO-DIMM Installation
WARNING:
Using incorrectly specified SO-DIMM may cause permanently damage
the PICOe-PV-D4251/N4551/D5251. Please make sure the purchased
SO-DIMM complies with the memory specifications of the
PICOe-PV-D4251/N4551/D5251. SO-DIMM specifications compliant
with the PICOe-PV-D4251/N4551/D5251 are listed in the specification
table of Chapter 1.
It is required that when adding additional memory that the SO-DIMM
match the DRAM organization of the onboard memory which is 64 MB
x16. The system will not boot if a SO-DIMM module that does not
match this DRAM organization is installed.
To install a SO-DIMM into a SO-DIMM socket, please follow the steps below and refer to
Figure 4-1.