3 lvds1 voltage selection, Figure 4-4: clear cmos jumper location, Table 4-3: clear cmos jumper settings – IEI Integration KINO-CV-D25501_N26001 User Manual
Page 67
KINO-CV-D25501/N26001 SBC
Page 53
use the jumper cap to close pins 2 and 3 for a few seconds then reinstall the jumper clip
back to pins 1 and 2.
If the “CMOS Settings Wrong” message is displayed during the boot up process, the fault
may be corrected by pressing the F1 to enter the CMOS Setup menu. Do one of the
following:
Enter the correct CMOS setting
Load Optimal Defaults
Load Failsafe Defaults.
After having done one of the above, save the changes and exit the CMOS Setup menu.
The clear CMOS jumper settings are shown in Table 4-3.
Pin Description
Short 1-2
Keep CMOS Setup (Default)
Short 2-3
Clear CMOS Setup
Table 4-3: Clear CMOS Jumper Settings
Figure 4-4: Clear CMOS Jumper Location
4.5.3 LVDS1 Voltage Selection
Jumper Label:
JP4
Jumper Type:
3-pin header
Jumper Settings: