1 at/atx mode selection, 2 clear cmos, Figure 4-8: at/atx mode selection jumper location – IEI Integration KINO-QM770 User Manual

Page 79: Table 4-2: at/atx mode selection jumper settings

Advertising

KINO-QM770 Mini-ITX SBC

Page 63

4.6.1 AT/ATX Mode Selection

Jumper Label:

J_ATXCTL1

Jumper Type:

3-pin header

Jumper Settings:

See Table 4-2

Jumper Location:

See Figure 4-8

Set both of the jumpers select AT or ATX power mode for the KINO-QM770. AT power

mode limits the system to on/off. ATX allows the system to use various power saving

states and enter a standby state, so the system can be turned on remotely over a network.

The settings on both jumpers should be the same.

Pin Description

Short 1-2

ATX mode (Default)

Short 2-3

AT mode

Table 4-2: AT/ATX Mode Selection Jumper Settings

Figure 4-8: AT/ATX Mode Selection Jumper Location

4.6.2 Clear CMOS

Jumper Label:

J_CMOS1

Jumper Type:

3-pin header

Jumper Settings:

See Table 4-3

Advertising