Figure 4-13: sata power drive connection – IEI Integration IMB-G41A User Manual
Page 74
IMB-G41A Micro-ATX Motherboard
Page 62
Figure 4-13: SATA Power Drive Connection
4.4.2 USB Cable (Dual Port) with Slot Bracket (Optional)
The IMB-G41A is shipped with a dual port USB 2.0 cable. To connect the USB cable
connector, please follow the steps below.
Step 5:
Locate the connectors. The locations of the USB connectors are shown in
Chapter 3.
WARNING:
If the USB pins are not properly aligned, the USB device can burn out.
Step 6:
Align the connectors. The cable has two connectors. Correctly align pin 1on
each cable connector with pin 1 on the IMB-G41A USB connector.
Step 7:
Insert the cable connectors
.
Once the cable connectors are properly aligned
with the USB connectors on the IMB-G41A, connect the cable connectors to the
on-board connectors. See Figure 4-14.