IEI Integration NANO-CV-D25501_N26001 - Manual (Page 80)

NANO-CV-D25501/N26001 EPIC SBC
Page 65
Step 4: Connect the serial device. Once the single RS-232 connector is connected to
a chassis or bracket, a serial communications device can be connected to the
system.
4.6.8 USB Cable (Dual Port without Bracket)
The NANO-CV-D25501/N26001 is shipped with a dual port USB 2.0 cable. To connect the
USB cable connector, please follow the steps below.
Step 1: Locate the connector. The location of the USB connector is shown in Chapter 3.
WARNING:
If the USB pins are not properly aligned, the USB device can burn out.
Step 2: Align the connectors. Correctly align pin 1on the cable connector with pin 1 on
the NANO-CV-D25501/N26001 USB connector.
Step 3: Insert the cable connectors. Once the cable connector is properly aligned with
the USB connector on the NANO-CV-D25501/N26001, connect the cable
connector to the on-board connector. See Figure 4-18.
Figure 4-18: Dual USB Cable Connection