IEI Integration PM-PV-N4551_D5251 - Manual (Page 53)

PM-PV-D4251/N4551/D5251 User Manual
Page 41
Figure 4-2: CompactFlash® Card Installation
4.6 Jumper Settings
NOTE:
A jumper is a metal bridge that is used to
close an electrical circuit. It consists of two
metal pins and a small metal clip (protected
by a plastic cover) that slides over the pins
to connect them. To CLOSE/SHORT a
jumper means connecting the pins of the
jumper with the plastic clip and to OPEN a
jumper means removing the plastic clip from a jumper.
Before the PM-PV-D4251/N4551/D5251 is installed in the system, the jumpers must be
set in accordance with the desired configuration. There are three jumpers on the
PM-PV-D4251/N4551/D5251. These three jumpers are listed in the table below.