IEI Integration PM-PV-N4551_D5251 - Manual (Page 56)

PM-PV-D4251/N4551/D5251 User Manual
Page 44
4.6.3 CompactFlash® Setup
Jumper Label: SW_CF1
Jumper Type: switch
Jumper Settings: See Table 4-4
Jumper Location: See Figure 4-5
The CompactFlash® slot is connected through an IDE connection. This switch sets the
CompactFlash® card as the master or slave IDE device.
Setting Description
Default position
(marked on board)
Slave
Other position Master
Table 4-4: CompactFlash® Setup Jumper Settings
Figure 4-5: CompactFlash® Setup Jumper Location
4.6.4 LVDS Voltage Selection
WARNING:
Incorrect voltages can destroy the LCD panel. Make sure to select a
voltage that matches the voltage required by the LCD panel.