IEI Integration ECW-281B-N270-WT v2.10 - Manual (Page 98)

ECW-281B-R21/N270 Embedded System
Page 82
Use the Remote Access option to enable or disable access to the remote functionalities
of the system.
Disabled D EFAULT
Remote access is disabled.
Enabled Remote access configuration options shown below
appear:
Serial Port Number
Serial Port Mode
Flow Control
Redirection after BIOS POST
Terminal Type
VT-UTF8 Combo Key Support
These configuration options are discussed below.
Serial Port Number [COM1]
Use the Serial Port Number option allows to select the serial port used for remote
access.
COM1 D EFAULT
System is remotely accessed through COM1
COM2
System is remotely accessed through COM2
NOTE : Make sure the selected COM port is enabled through the Super I/O configuration
menu.
Base Address, IRQ [2F8h,3]
The Base Address, IRQ option cannot be configured and only shows the interrupt
address of the serial port listed above.
Serial Port Mode [115200 8,n,1]