IEI Integration TANK-101B-D525_N455 v1.10 - Manual (Page 27)

TANK-101B/BW Embedded System
Page 16
Step 3: Attach the HDD to the HDD bracket, and then slide the HDD to connect the HDD
to the SATA connector (Figure 3-4).
Figure 3-4: HDD Installation
Step 4: Secure the HDD with the HDD bracket by four retention screws (Figure 3-4).
Step 5: Reconnect the SATA signal and power cables to the TANK-101B/BW.
Step 6: Reinstall the bottom panel.
3.4 Mounting the System with Mounting Brackets
To mount the embedded system onto a wall or some other surface using the two mounting
brackets, please follow the steps below.
Step 1: Turn the embedded system over.
Step 2: Align the two retention screw holes in each bracket with the corresponding
retention screw holes on the sides of the bottom surface.