IEI Integration TANK-800-D525 v1.00 - Manual (Page 33)

TANK-800 Embedded System
Page 23
Step 4: Connect the system fan cable to the CPU_FAN1 connector on the motherboard
of TANK-800.
Step 5: Reconnect the SATA signal and power cables to the TANK-800.
Step 6: Reinstall the cover.
3.5 Pluggable DC-In Terminal Block Installation
To install the pluggable DC-in terminal block, please follow the steps below:
Step 1: Locate the DC-in terminal block connector. The location of the connector is
shown in Figure 1-2.
Step 2: Align the pluggable DC-in terminal block with the DC-in terminal block connector
on the TANK-800.
Step 3: Once aligned, insert the pluggable DC-in terminal block into the DC-in terminal
block connector.
Step 4: Secure the pluggable DC-in terminal block to the external interface by tightening
the two retention screws on either side of the terminal block (Figure 3-9).
Figure 3-9: Pluggable DC-in Terminal Block Installation