IEI Integration TANK-800-D525 v1.00 - Manual (Page 40)

TANK-800 Embedded System
Page 30
Figure 3-17: Power Input Connector
Pin Description Pin Description
1 +12V 3 +12V
2 GND 4 GND
Table 3-4: Power Input Pinouts
3.7.9 RJ-45 RS-422/485 Serial Ports
CN Label: RS422/485
CN Type: RJ-45
CN Location: See Figure 1-2
CN Pinouts: See Table 3-5 and Figure 3-19
RS-422/485 serial port devices can be attached to the RJ-45 RS-422/485 serial ports on
the rear panel.
Step 1: Locate the RJ-45 RS-422/RS485 connectors . The locations of the RJ-45
RS-422/RS-485 connectors are shown in Figure 1-2.
Step 2: Insert the RJ-45 connector. Insert the RJ-45 connector on the RJ-45 to DB-9
COM port cable to one of the RJ-45 RS-422/485 connectors on the TANK-800.
See Figure 3-18.