IEI Integration TANK-GM45A - Manual (Page 30)

TANK-GM45 Embedded System
Page 20
3.4.5 RS-232 Serial Port Connector
CN Label: COM1
CN Type: DB-9 connectors
CN Location: See Figure 3-7
CN Pinouts: See Table 3-8 and Figure 3-14
RS-232 serial port devices can be attached to the DB-9 ports on the rear panel.
Step 1: Locate the DB-9 connector . The location of the DB-9 connector is shown in
Figure 3-7 .
Step 2: Insert the serial connector . Insert the DB-9 connector of a serial device into
the DB-9 connector on the external peripheral interface. See Figure 3-13.
Figure 3-13: Serial Device Connector
Step 3: Secure the connector . Secure the serial device connector to the external
interface by tightening the two retention screws on either side of the connector.
Step 0: