IEI Integration IDS-H61 - Manual (Page 53)

IDS-H61 Digital Signage Player
Page 43
Step 3: Remove the mSATA module . Push the two spring clips in to release the
mSATA module.
Step 4: Insert a new mSATA module into the socket at an angle . Line up the notch
on the card with the notch on the connector. Slide the mSATA module into the
socket at an angle of about 20º (Figure 5-3).
Figure 5-3: mSATA Module Installation
Step 5: Push down until the card clips into place . Push the other end of the card
down until it clips into place on the plastic connector. Step 0:
5.2.2 SO-DIMM Replacement
WARNING:
Using incorrectly specified SO-DIMM may cause permanently damage
the IDS-H61. Please make sure the purchased SO-DIMM complies
with the memory specifications of the IDS-H61.
To replace a SO-DIMM memory module into a SO-DIMM socket, please follow the steps
below.