IEI Integration ECN-360A-D2550 - Manual (Page 26)

ECN-360A-D2550 Em b e d d e d S ys te m
P a g e 15
S te p 3: Attach the HDD to the HDD bracket, and then slide the HDD to connect the HDD
to the SATA connector. Secure the HDD with the HDD bracket by four retention
screws (Figure 3-3).
Figure 3-3: HDD Retention Screws
S te p 4: Replace the HDD cover and secure it using six previously removed retention
screws.
3.4 Wi-Fi An te n n a In s ta lla tio n (Wire le s s Mo d e l On ly)
To install the Wi-Fi antennas to the ECN-360A-D2550 series for efficient wireless network
transmission, follow the steps below.
S te p 1: Locate the antenna connectors on the rear panel of the embedded system.
S te p 2: Install the antennas to the antenna connectors (Figure 3-4).