IEI Integration EBC-3100 - Manual (Page 5)

EBC-3100 IEI Technology Corp. Page 5
Figure 6: SBC Retention Screws
Step 2: Align the retention screw holes on the SBC with the
metal post retention screw holes.
Step 3: Insert the four retention screws to secure the SBC
to the chassis.
Step 4: Connect the power supply to the SBC according to
the SBC user manual.
INSTALL HDD
To install a 3.5” SATA HDD, please follow the steps below.
Step 1: Attach the HDD to the HDD bracket. To do this,
slide the HDD into the HDD bracket with the SATA
cable and power connects at the rear of the bracket
as shown in the figure below.
Figure 7: HDD Bracket (Top)
Step 2: Attach the HDD to the HDD bracket. Align the
retention screw holes in the sides of the bracket
with the retention screw holes on the HDD. Insert
the retention screws into the bracket to secure the
HDD as seen below.
Figure 8: HDD Retention Screws (Bottom)
Step 3: Attach SATA and power cable to HDD and SBC as
shown below.
Figure 9: SATA Cables
Step 4: Install the bracket with HDD into the chassis by
aligning the bracket retention screw holes in the top
of the HDD bracket with the retention screw holes
on the chassis. Insert the four previously removed
retention screws into the top of the HDD bracket as
shown in the figure below.