IEI Integration EBC-3100 - Manual (Page 7)

EBC-3100 IEI Technology Corp. Page 7
REINSTALL CHASSIS COVER
Step 1: Replace chassis cover.
Step 2: Reinsert the two retention screws.
WALL MOUNTING (OPTIONAL)
To mount the embedded system onto a wall using the wall mount bracket
kit, please follow the steps below.
Step 1: Attach the wall mounting brackets to the chassis
with the four bracket retention screws as shown in
the figure below.
Figure 13: Wall-mounting Bracket and Retention Screw
Locations
Step 2: Select the location on the wall for wall mounting
screws.
Step 3: Carefully mark the locations of the four bracket
screw holes on the wall.
Step 4: Drill four pilot holes at the marked locations on the
wall for the wall mounting screws.
Step 5: Insert the four wall mounting screws into the pilot
holes in the wall.
Step 6: Align the holes on the bracket with the wall
mounting screws in the wall. See figure below.
Step 7: Insert the screws through the holes and gently pull
the chassis downwards until it rests securely in the
slotted holes. Ensure that all four of the mounting
screws fit snuggly into their respective slotted holes.
Step 8: Tighten the wall mounting screws to secure system
to the wall.
Figure 14: Wall-mounting the EBC-3000
EBC-3100 MAINTANENCE
The following EBC-3100 components may be replaced if they fail:
„
Power Supply Replacement
„ System Fan Replacement
POWER SUPPLY REPLACEMENT
A power supply is installed in the chassis. To replace the power supply,
please follow the instructions below.
Step 1: Disconnect the power supply connector cable from
the SBC.
Step 2: Remove the three power supply retention screws
on the front panel of the chassis as indicated below.
Figure 15: Power Supply Retention Screws
Step 3: Remove the power supply bracket retention screws
that secure the power supply to the bottom of the
chassis as shown below.
Step 4: Remove the power supply from the chassis and
remove the screws securing the bracket to the
power supply.