1 unpacking, Npacking, 1 un pa c kin g – IEI Integration UPC-V315-QM77 User Manual
Page 27
UP C-V315-QM77 P a n e l P C
P a g e 16
2.1 Un pa c kin g
To unpack the panel PC, follow the steps below:
WARNING!
The front side LCD screen has a protective plastic cover stuck to the
screen. Only remove the plastic cover after the panel PC has been properly
installed. This ensures the screen is protected during the installation
process.
S te p 1:
Use box cutters, a knife or a sharp pair of scissors that seals the top side of the
external (second) box.
S te p 2:
Open the external (second) box.
S te p 3:
Use box cutters, a knife or a sharp pair of scissors that seals the top side of the
internal (first) box.
S te p 4:
Lift the monitor out of the boxes.
S te p 5:
Remove both polystyrene ends, one from each side.
S te p 6:
Pull the plastic cover off the panel PC.
S te p 7:
Make sure all the components listed in the packing list are present.
S te p 0: