IEI Integration AFL-W19A_W19B_17D_W15A-GM45 v2.10 - Manual (Page 59)

AFL-W19A/W19B/17D/W15A-GM45 Panel PC
Page 47
NOTE:
Identical baud rate setting musts be set on the host (a management
computer running a terminal software) and the slave
Î Flow Control [None]
Use the Flow Control option to report the flow control method for the console redirection
application.
Î
None D EFAULT
No control flow,
Î
Hardware Hardware is set as the console redirection
Î
Software
Software is set as the console redirection
Î Redirection After BIOS POST [Always]
Use the Redirection After BIOS POST option to specify when console redirection should
occur.
Î
Disabled The console is not redirected after POST
Î
Boot Loader Redirection is active during POST and during Boot
Loader
Î
Always D EFAULT
Redirection is always active (Some OSes may not
work if set to Always)
Î Terminal Type [ANSI]
Use the Terminal Type BIOS option to specify the remote terminal type.
Î
ANSI D EFAULT
The target terminal type is ANSI
Î
VT100
The target terminal type is VT100
Î
VT-UTF8 The target terminal type is VT-UTF8