IEI Integration AFL-xxA-N270-Series v2.30 - Manual (Page 51)

AFL-xxA-N270 Series Panel PC
Page 35
Panel type and resolution J_LCD_TYPE1 10-pin header
Touchscreen selection J1 4-pin header
USB2 and USB4 power selection JP15 6-pin header
Table 4-2: Preconfigured Jumpers
4.9.3 Clear CMOS Jumper
Jumper Label: J_CMOS1
Jumper Type: 2-pin header
Jumper Settings: See
7
Table 4-3
Jumper Location: See
7
Figure 4-7
If the AFL-xxA-N270 fails to boot due to improper BIOS settings, the clear CMOS jumper
clears the CMOS data and resets the system BIOS information. To do this, use the jumper
cap to close the pins for a few seconds then remove the jumper clip.
If the “CMOS Settings Wrong” message is displayed during the boot up process, the fault
may be corrected by pressing the F1 to enter the CMOS Setup menu. Do one of the
following:
ƒ Enter the correct CMOS setting
ƒ Load Optimal Defaults
ƒ Load Failsafe Defaults.
After having done one of the above, save the changes and exit the CMOS Setup menu.
The clear CMOS jumper settings are shown in
7
Table 4-3 .
Clear CMOS Description
Short 1 - 2 Keep CMOS Setup Default
Short 2 - 3 Clear CMOS Setup
Table 4-3: Clear CMOS Jumper Settings
The location of the clear CMOS jumper is shown in
7
Figure 4-7 below.