IEI Integration AFL-W10A-N270 v2.13 - Manual (Page 48)

AFL-W10A-N270 User Manual
Page 48
Figure 2-20: Serial Device Connector
Step 3: Secure the connector . Secure the serial device connector to the external
interface by tightening the two retention screws on either side of the connector.
Step 0:
2.7.3 USB Device Connection
There are four external USB 2.0 connectors. All connectors are perpendicular to the
AFL-W10A-N270. To connect a USB 2.0 or USB 1.1 device, please follow the instructions
below.
Step 1: Located the USB connectors . The locations of the USB connectors are shown
in Chapter 2.
Step 2: Align the connectors. Align the USB device connector with one of the
connectors on the bottom panel. See Figure 2-21.