IEI Integration AFL-F08A v1.01 - Manual (Page 44)

AFL-F08A Panel PC
Page 32
Step 3: Align the retention screw holes on the mounting arm interface with those in the
flat panel PC.
Figure 3-17: Arm Mounting Retention Screw Holes
Step 4: Secure the system to the interface pad by inserting four retention screws
through the bottom of the mounting arm interface pad and into the flat panel PC.
Step 0:
3.8.4 Cabinet and Rack Installation
The AFL-F08A can be installed into a cabinet or rack. The installation procedures are
similar to the panel mounting installation. To do this, please follow the steps below:
NOTE:
When purchasing the cabinet/rack installation bracket, make sure it is
compatible with both the AFL-F08A and the rack/cabinet into which the
AFL-F08A is installed.
Step 1: Slide the rear chassis of the AFL-F08A through the rack/cabinet bracket until the
aluminum frame is flush against the front of the bracket (Figure 3-18).