IEI Integration AFL-F08A v2.10 - Manual (Page 27)

AFL-F08A-N270 Panel PC
Page 15
ƒ Anti-static Discharge: If a user open the rear panel of the flat panel PC, to
configure the jumpers or plug in added peripheral devices, ground themselves
first and wear and anti-static wristband.
3.3 Installation and Configuration Steps
The following installation steps must be followed.
Step 1: Unpack the system
Step 2: Install a CF card
Step 3: Configure the system
Step 4: Connect peripheral devices
Step 5: Mount the system Step 0:
3.4 Removing the Back Cover
WARNING:
Over-tightening back cover screws will crack the plastic frame.
Maximum torque for cover screws is 5 kg-cm (0.36 lb-ft/0.49 Nm).
To access the AFL-F08A-N270 internally the back cover must be removed. To remove the
back cover, please follow the steps below.