3 installation and configuration steps, 4 hdd installation, Nstallation and – IEI Integration AFL2-W10A-N28 User Manual
Page 37: Onfiguration, Teps, Nstallation
AFL2-W10A-N28 Panel PC
Page 19
Anti-static Discharge: If a user open the rear panel of the flat bezel panel PC,
to configure the jumpers or plug in added peripheral devices, ground
themselves first and wear an anti-static wristband.\
3.3 Installation and Configuration Steps
The following installation steps must be followed.
Step 1:
Unpack the flat bezel panel PC.
Step 2:
Install the HDD.
Step 3:
Install the RFID reader. (optional)
Step 4:
Configure the system.
Step 5:
Connect peripheral devices to the flat bezel panel PC.
Step 6:
Mount the flat bezel panel PC.
Step 0:
3.4 HDD Installation
WARNING:
Over-tightening back cover screws will crack the plastic frame.
Maximum torque for cover screws is 5 kg-cm (0.36 lb-ft/0.49 Nm).
To install the HDD into the AFL2-W10A-N28, please follow the steps below:
Step 1:
Remove two (2) retention screws from the HDD cover (
8
Figure 3-1).