1 12 v~36 v dc terminal block, 2 rs-232/422/485 serial port, 1 connecting the serial port – IEI Integration IOVU-572M User Manual
Page 25: Figure 4-3: power terminal block, Table 4-2: 12~36 v power connector pinouts
IOVU-572M Panel PC
Page 18
4.3.1 12 V~36 V DC Terminal Block
The power terminal block connects to a 12~36 V DC power source.
CN Label:
12-36 V
CN Type:
Terminal block
CN Location: See Figure 4-2
CN Pinouts:
Pin Description
1
12~36 V DC Power in
2 GND
Table 4-2: 12~36 V Power Connector Pinouts
Figure 4-3: Power Terminal Block
4.3.2 RS-232/422/485 Serial Port
This section outlines the usage and setup of the serial port on the rear I/O panel.
4.3.2.1 Connecting the Serial Port
The IOVU-572M has a single female DB-9 connector on the external peripheral interface
panel for a serial device. Follow the steps below to connect a serial device to the
IOVU-572M.
Step 1:
Insert the serial connector
.
Insert the DB-9 connector of a serial device into
the DB-9 connector on the external peripheral interface. See Figure 4-4.