IEI Integration IOVU-572M - Manual (Page 37)

IOVU-572M Panel PC
Page 30
Figure 4-18: Tighten the Panel Mounting Clamp Screws
4.4.3 Arm Mounting
The IOVU-572M is VESA (Video Electronics Standards Association) compliant and can be
mounted on an arm with a 75 mm interface pad. To mount the IOVU-572M on an arm,
please follow the steps below.
Step 15: The arm is a separately purchased item. Please correctly mount the arm onto
the surface it uses as a base. To do this, refer to the installation documentation
that came with the mounting arm.
NOTE:
When purchasing the arm please ensure that it is VESA compliant and
that the arm has a 75 mm interface pad. If the mounting arm is not
VESA compliant it cannot be used to support the IOVU-572M.
Step 16: Once the mounting arm has been firmly attached to the surface, lift the
IOVU-572M onto the interface pad of the mounting arm.