4 memory module replacement, Emory, Odule – IEI Integration EP-308A v1.15 User Manual
Page 95: Eplacement, Figure 4-1: bottom cover retention screws
Advertising
EP-308A/EP-308AS POS
Page 85
Figure 4-1: Bottom Cover Retention Screws
4.4 Memory Module Replacement
The flat panel PC has a preinstalled memory module. If the memory module fails, take the
steps below to replace it.
Step 1:
Remove the back cover. See Section 4.3 above.
Step 2:
Locate the memory module on the motherboard of the flat panel PC
Step 3:
Remove the memory module by pulling both the spring retainer clips outward
from the socket.
Step 4:
Grasp the memory module by the edges and carefully pull it out of the socket.
Step 5:
Install the new memory module by inserting it at an angle, then pushing down
until the clips snap into place (Figure 4-2).
Step 0:
Advertising