IEI Integration RACK-2100G - Manual (Page 3)

RACK-2100G QIG
IEI Technology Corp. Page 3
INSTALLATION STEPS
Compete the following installation steps to install the RACK-2100G
chassis.
Step 1: Unpack the chassis.
Step 2: Install the front handles.
Step 3: Remove the top cover.
Step 4: Install a PSU.
Step 5: Install a backplane.
Step 6: Install a CPU card.
Step 7: Install PCI and ISA expansion cards.
Step 8: Install the backplane bracket.
Step 9: Install disk drives.
Step 10: Connect cables.
Step 11: Connect the PSU cable and interface cable.
Step 12: Reinstall the top cover. Step 0:
The installation steps outlined above are described in detail below.
STEP 1: UNPACK
The RACK-2100G is shipped in a plastic bag that is placed inside a
cardboard box. The items are also shipped with the chassis. When
unpacking the chassis:
„
Make sure all the items listed in the PACKING LIST section are
present.
„ Make sure the chassis has not been damaged in any way.
STEP 2: FRONT HANDLE INSTALLATION
Two handles are shipped with the RACK-2100G chassis. Each
handle is secured to the chassis with four retention screws, one each
on the left and right side panels near the front panel. Follow the
steps below to install the handles.
Step 1: Align the retention screw holes on the side of the
chassis with the retention screws holes in the handle.
Step 2: Insert four retention screws for each handle. Step 0:
Figure 3: Front Handle Retention Screws
STEP 3: REMOVE THE TOP COVER
The top cover of the chassis is connected to the chassis with seven
retention screws, three each on the left and right side panels and
one near the rear of the top cover. Follow the steps below to remove
the top cover.
Step 1: Remove all seven retention screws. Remove six screws
from the sides of the chassis, and one retention screw
located near the rear of the top cover.
Figure 4: Top Cover Retention Screws
Step 2: Slide the cover backwards, lifting gently. Step 0:
Figure 5: Remove the Top Cover