IEI Integration RACK-2100G - Manual (Page 8)

RACK-2100G QIG
IEI Technology Corp. Page 8
Figure 21: Backplane Bracket Chassis Retention Screws
Figure 22: Backplane Bracket Rear Panel Retention Screws
STEP 9: DISK DRIVE INSTALLATION
The RACK-2100G/GR chassis can support:
o 1 x FDD, 1 x HDD and 1 x Optical drive, or
o 2 x HDDs and 1 x Optical drive
One 3.5” FDD/HDD drive and one optical drive are mounted into a
single drive bracket. Another HDD is installed into an internal 3.5”
drive bracket. Follow the steps in the sections below to install the
drives.
S TEP 9.1: I NTERNAL 3.5＂HDD D RIVE B RACKET
Follow the steps below to install an HDD in the internal 3.5” HDD
bracket.
Step 1: Remove the 3.5” internal HDD bracket by removing the
four retention screws that attach the bracket to the
chassis base.
Figure 23: 3.5＂HDD Bracket Retention Screws
Step 2: Mount the HDD in the bracket. Make sure the HDD does
not block any of the retention screw holes at the corners
of the bracket and that the HDD PCB board is facing the
bottom of the bracket.
Step 3: Insert four retention screws, two on each side of the
bracket, to secure the HDD.
Figure 24: HDD Retention Screws (Opposite Side Similar)
Step 4: Once the HDD is secured, the HDD bracket can be
reinstalled. Remount the bracket making sure the power
connector and the IDE/SATA connector of HDD face the
main drive bracket and reinsert the previously removed
retention screws. Step 0:
Figure 25: HDD Bracket Retention Screws