Northstar Trailers SPORTSTAR II WG - Manual (Page 13)

INSTALL FRONT CORNER BRACKETS (with ramp mounts)
a. Install the retaining cables (S) by looping them over the round knob on the
back of the bracket.
b. Insert the knob on the bracket into the hole of the side-rail.
c. Attach the bracket to the trailer frame using 1” bolts, washers and lock-
washers.
TIGHTEN AND SECURE ALL BOLTS! After all side-rails and brackets are in their
proper positions, make sure to securely tighten all bolts, and make sure that all
cotter-pins are installed in the side-rail pins. Make sure that at least one leg of
cotter-pin is bent to 90 degrees.
Note: the front brackets run parallel to the front of the trailer and store/carry the
trailer ramps.
STEP 9: MOUNT TRAILER RAMPS & INSTALL REAR GATE
a. Mount the trailer ramps (6) on the front corner brackets, and secure the
ramps to the brackets by sliding the ramp-pins through the eyeholes on each
end of the ramps.
b. Secure the ramps to the brackets by inserting the cotter-pins from the
retaining cables.
c. Position the rear gate (13) so that the gate’s pin-slots sit in-between the pin-
slots on the trailer frame.
d. Connect the gate’s pin-slots with those on the trailer using the gate-pins (F).
e. Secure the gate-pins with the cotter-pins, and then secure the cotter-pins by
bending at least one leg to 90 degrees.
YOU ARE FINISHED! We hope that you enjoy your NORTHSTAR TRAILER. Please
contact us at 1-855-375-3088 or email [email protected] if you have any
questions. Our business hours are Monday-Friday 9:00 a.m. to 5:00 p.m. MST.
TRAILER SPECIFICATIONS
Trailer Weight: 580 lb.s
Towing Capacity: 1,420 (GVWR)
Length (w/ tongue): 178”
Width: 73”
Tire Size: 13x175
Note: The dealer that sold you this trailer will ship you the trailer’s Certificate of
Origin. The certificate will arrive approximately two weeks after the trailer is
delivered.