Step 4: attach tongue to frame, Step 5: final wiring adjustment – Northstar Trailers SPORTSTAR II WG User Manual

Page 9

Advertising
background image

STEP 4: ATTACH TONGUE TO FRAME

Remember: the trailer is still upside-down, so all components must be installed upside-

down.

a. *Make sure that the tongue’s wiring harness extends out from both the back

and the front of the tongue.

b. Align the tongue’s (2) eyeholes with the eyeholes on the frame.

c. Use the 3 5/8” threaded pin-bolts (E) and large nuts (H) to fasten the tongue

to the frame.

Note: do not fully tighten the bolts or install the cotter-pins until the side-braces

are installed. Be careful not to pinch or cut the tongue’s wiring harness when
inserting the bolts.

d. Attach the side-braces (11) to the tongue of trailer using 3 ½” threaded pin-

bolt (D) and a large nut (H).

e. Attach the side-braces to the frame using 1” bolts (L), flat-washers (K) and

small lock-nuts (C). (NORTHSTAR will read upside down).

f. Once the side-braces are attached, tighten the 3 5/8” bolts from step “c” as

tight as a manual wrench will allow. Then insert cotter-pins, and secure the

cotter-pins by bending at least one leg to 90 degrees.

g. Check and make sure that all other bolts are tight.

h. Securely tighten the bolts that connect the trailer’s coupler/hitch to the

tongue. (These bolts are loose. You must tighten them).

*Note: In rare cases the tongue’s wiring harness may fall inside the tongue after

shipping and unpacking, and you may need to fish the wires and pull them out of the

tongue.

TIGHTEN AND SECURE ALL BOLTS! After the tongue and the side braces are in

their proper positions, make sure to securely tighten all bolts, and make sure that all

cotter-pins are installed, and that at least one leg of the cotter-pin is bent to 90
degrees.

STEP 5: FINAL WIRING ADJUSTMENT

a. Ensure that the tow-vehicle connector (trailer plug) and wires that extend

from the hitch have sufficient slack to connect to the vehicle’s receptor plug.

b. Plug together the tongue’s wiring harness with the trailer frame’s wiring

harness.

c. Tuck any excess wire and the main wiring connector into the base of the

tongue.

Advertising