ODL Brisa Retractable Screen Doors - double doors - Manual (Page 8)

7
Product modification
There are two separate scenarios that will require modifications before proceeding
to the installation steps. Door trim openings that measure less than 68" will require
track cutting to fit the door width. Outswing door installations require a change to
the handle/lock assembly to move the lock mechanism to the inside of the home.
Locking
Latch
OUTSWING DOOR
HANDLE MODIFICATION
Remove the two screws on the
handle assembly on the slider bar
of the latch housing.
Remove the slider bar end cap and
slide the handle assembly all the way
to the open end of the slider bar.
Slide the latch handle off
completely and flip the handle
end-to-end.
Re-insert the handle assembly,
making sure the handle tabs slide
into the tracks of the slider bar.
TIP: Locking latch and housings
should be on the inside of the
home when installed.
NARROW DOOR
TRACK MODIFICATION
Measure your door trim opening and
follow the example below to make
your modifications.
EXAMPLE
68"
standard door width
- 66"
existing door width
= 2"
+ 1-7/8"
= 3-7/8"
total amount to be cut
from the ends of the top
and bottom tracks