ODL Standard Retractable Screen Door - replacement cartridges - Manual (Page 4)

Locate the end cap marked R
Remove the screws that secure the end cap marked R.
The end cap can then be removed from the housing.
You may hear the release of the spring tension which is normal.
Remove the pull handle end cap
Locate the pull handle end cap on the opposite end from the housing
end cap you just removed. Remove screw/s that hold the pull handle
end cap in place and remove the cap. You can now withdraw the
pull handle from the damaged screen.
Remove the damaged screen
You can now remove the entire damaged screen roll & discard.
If you have an “RTM” screen you will need to remove the ball bearing
from your damaged screen and insert it in your new screen.
You will need to remove the damper (has a plastic gear on it)
from the new screen in order to do this.
Install the new screen roll.
Remove the new screen from it’s packaging - leave the tape holding
the screen roll in place. Identify the tension pin end of the new
screen - this is the end with the flat metal pin protruding. Carefully
insert the metal tension pin into the slot on the end cap that is still
secured to the housing. Make sure it is seated properly and kept
there for the next few steps.
Pull Handle
Screen Housing
Lay the unit down on a
flat carpeted surface. Remove Pull Handle end
cap from opposite end
of housing end cap “R”.
Pull Handle
End Cap
Remove 2 screws
Remove pull handle
end cap and slide
pull handle off.
Insert flat metal tension
pin of new screen into
end cap on housing.
Step
3
Step
4
Step
5
Step
6
ODL ® Retractable Screen Replacement Screen Instructions
Picture shown is “RTS”.
Follow same instructions
for “RET” and “RTM”.
End Cap marked “R”
Remove 2-3 screws
then remove cap.