ODL Standard Retractable Screen Door - replacement cartridges - Manual (Page 6)

Screen should be located
to travel between end cap
flange and housing.
ODL ® Retractable Screen Replacement Screen Instructions
Step
10
Step
13
Check for operation on door
With all screws securely installed you can now test the
operation of the installed unit. It should open and close
smoothly with no binding. If binding occurs, first check that
the screws securing the housing are not over tightened.
If binding still occurs, check the helpful tips on the
next page.
Install the screen tracks (For “RTS” Only)
A) Thread bead on track through hole in screen end
cap. Flat end of track lies flush with back of screen
housing.
B) With the screen track properly threaded through
the screen end cap, install your 1/2” flat head
screws, as shown.
Step
11
Install screen housing / tracks to door
Take your screen housing / track assembly to the door.
Use the existing holes as a guide for correct position.
Once the correct position is obtained, install your track,
sill cover and housing screws. Be sure you don’t
overtighten your track screws, for that could cause
binding of the screen.
Step
12
(A)
(B)
Pictures shown are “RTS”.
Check screen path and test operation
Unwrap the screen from around the housing. The
screen itself should follow the path through the end
cap channels as shown in the detailed illustration. If
it doesn’t, carefully manuever the screen into position.
You can now test the screen for proper operation by
extending it and letting it retract. It should operate
smoothly and not retract with excessive force.