Atlas Sound AH99-12ST - Manual (Page 11)

Specifications are subject to change without notice
AtlasSound.com
1601 JACK MCKAY BOULEVARD ENNIS, TEXAS 75119 U.S.A. • TELEPHONE: (800) 876-3333 • FAX: (800) 765-3435
©2006 ATLAS SOUND LP Printed in U.S.A. 000606 ATS002386 RevA 6/06 PP
INSTALLATION INSTRUCTIONS
AH SERIES LOUDSPEAKERS
8", 12", AND 15"
11
SPECIFICATIONS
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE REMEDY
Call Atlas Sound tech support at 1-800-876-3333 with any additional questions.
8" MODELS POWER RATING FREQUENCY
RES. ±5dB
SOUND LEVEL DISPERSION IMPEDANCE XFMR TAPS DIMENSIONS WEIGHT
RP/1M 1W/1M
AH99-8ST 100 Watts 90Hz to 10kHz 121dB 101dB 90° H
90° V
8Ω Nominal 7.5, 15,
30, and 60
Watts
23.86" (606mm) D
21.41" (544mm) W
21.25" (540mm) H
65 lbs
(24.5 kg)
AH94-8ST 100 Watts 90Hz to 10kHz 121dB 101dB 90° H
40° V
8Ω Nominal 7.5, 15,
30, and 60
Watts
21.83" (554mm) D
19.66" (499mm) W
18.41" (468mm) H
63 lbs
(28.6 kg)
AH66-8ST 100 Watts 90Hz to 10kHz 120dB 100dB 65° H
65° V
8Ω Nominal 7.5, 15,
30, and 60
Watts
20.91" (531mm) D
17.91" (455mm) W
19.66" (499mm) H
61 lbs
(27.7 kg)
There is no sound Power off. Equipment setting is wrong.
Volume set too low.
Assure that power is applied to all equipment in system. Check
that routing (input/output) controls are set correctly. Check that
volume level is above minimum.
Loose connection. Check system from start to fi nish for crossed wires, loose
connection, etc. On the AH location check for correct connection.
Low sound level Setting/volume control is set too low.
Connection is shorted or bad.
Check volume levels or amplifi ers and related equipment
(equalizer). Check that connections aren't partially shorted/
corroded.
Sound cuts in and out System overload/oscillation intermittent connection. Check for overload condition or bad connection.
Distortion at increased levels Amplifi er/speaker overdriven. Check that power to speaker isn't over limits. Check that amplifi er
isn't overdriven. Reduce power to amplifi er slightly.
Speaker makes "buzzing" noise Hardware loose or speaker damaged. Make sure speaker grille is tight. Check other hardware
connections. Check speakers for loose parts or speaker damage.
12" MODELS POWER RATING FREQUENCY
RES. ±5dB
SOUND LEVEL DISPERSION IMPEDANCE XFMR TAPS DIMENSIONS WEIGHT
RP/1M 1W/1M
AH99-12ST 200 Watts 80Hz to 10kHz 126dB 103dB 90° H
90° V
8Ω Nominal 7.5, 15,
30, and 60
Watts
25.65" (652mm) D
22.06" (560mm) W
21.25" (540mm) H
87 lbs
(39.5 kg)
AH94-12ST 200 Watts 80Hz to 10kHz 126dB 103dB 90° H
40° V
8Ω Nominal 7.5, 15,
30, and 60
Watts
25.65" (652mm) D
22.06" (560mm) W
21.25" (540mm) H
85 lbs
(38.6 kg)
AH66-12ST 200 Watts 80Hz to 10kHz 125dB 102dB 65° H
65° V
8Ω Nominal 7.5, 15,
30, and 60
Watts
23.86" (606mm) D
21.41" (544mm) W
21.25" (540mm) H
82 lbs
(37.2 kg)
15" MODELS POWER RATING FREQUENCY
RES. ±5dB
SOUND LEVEL DISPERSION IMPEDANCE DIMENSIONS WEIGHT
RP/1M 1W/1M
AH5040S 250 Watts 75Hz to 14.5kHz 127dB 104dB 50° H
40° V
8Ω Nominal 20.5" (521mm) D
20.5" (521mm) W
32" (813mm) H
87 lbs
(39.5 kg)
AH6565S 250 Watts 75Hz to 14.5kHz 126dB 102dB 65° H
65° V
8Ω Nominal 20.5" (521mm) D
20.5" (521mm) W
32" (813mm) H
87 lbs
(89.5 kg)
AH9040S 250 Watts 75Hz to 14.5kHz 126.5dB 102.5dB 90° H
40° V
8Ω Nominal 22.5" (572mm) D
30" (762mm) W
31" (787mm) H
100 lbs
(45.4 kg)