Powermate PM0106500.02 - Manual (Page 7)

Customer Hotline 1-800-445-1805 7 English
T. DC Usage
This Generator is equipped with a cigarette lighter style
12V DC receptacle. The maximum draw for this DC outlet is
8.3 Amps. The 12V DC receptacle is not intended for use to
charge automotive batteries.
The cigarette lighter style receptacle permits the use of
any electrical device designed for use in a 12V DC cigarette
style outlet similar to ones found in automobiles. The
electrical device has a power cord with a metal pin on the
bottom and two leaf springs on the sides. Some common
automotive type electrical devices are inflators, vacuum
cleaners, chargers of various types and more.
To Use: Simply plug the electrical device power cord into
the 12V DC outlet and ensure the power cord is securely in
place. Use the device as instructed. Remove after use by
simply pulling the power cord out of the receptacle. The 12V
DC receptacle is protected against overloads by an in-line fuse
located behind the control panel.
GROUND FAULT CIRCUIT INTERRUPTER (GFCI)
PROTECTION
Some jobsites and local codes may require GFCI
protection for personnel before operation of your generator. If
your generator is not already equipped with a GFCI
receptacle, GFCI In-line cord sets may be purchased from
your local electrical supply store or home builder appliance
store.
These cord sets are available in various plug and
amperage configurations. (Make sure your generator is
properly Grounded.)
GROUNDING THE GENERATOR
The National Electric Code requires that this product be
properly connected to an appropriate earth ground to help
prevent electric shock. A ground terminal connected to the
frame of the generator has been provided for this purpose.
Connecting a length of heavy gauge (12 AWG min.) copper
wire between the generator Ground Terminal and a copper rod
driven into the ground should provide a suitable ground
connection. However, consult with a local electrician to insure
that local codes are being adhered to.
LUBRICATION
DO NOT attempt to start this engine without filling the
crank case with the proper amount and type of oil. Your
generator has been shipped from the factory without oil in the
crankcase. Operating the unit without oil can damage the
engine.
Fill the engine with oil according to the operator manual.
For units with a dipstick, fill oil to the proper level. Units
without a dipstick should be filled to the top of the opening of
the oil fill.
GROUND TERMINAL LOCATION:
BEFORE OPERATION
Do not use a pipe carrying combustible material as
the ground source.
Ground
Terminal
GENERATOR FEATURES - DC USAGE