Qualcraft Stingray Anchor - Manual (Page 13)

Installation and Use
G
ua
rd
ia
n
Fa
ll
Pr
ot
ec
tio
n
6
30
5
S.
2
31
st
S
t.
, K
en
t,
W
A
9
80
32
p
ho
ne
: (
80
0)
4
66
-6
38
5
f
ax
: (
80
0)
6
70
-7
89
2
w
w
w
.g
ua
rd
ia
nf
al
l.c
om
11
Compatible Beam Flange Measurements:
Width: 5” - 13”
Maximum thickness: 3--3/8”
Stingray Anchors MUST NOT be used as permanent anchors. NEVER install on bottom beam
flange.
Stingray Anchors MUST ONLY be installed on horizontal structural steel “I” beams capable of
withstanding 5,000 lbs. per PFAS in complete system.
Max 60’
Stingray Anchors may be used as independent anchorage connectors OR as components of a
complete HLL system. In HLL applications, Stingray Anchors stop falls by allowing the attached
steel cable to stretch via the bending and deflection of system posts, and via PFAS equipment
worn by user. In the event of a fall, some deformation of the building structure or steel support
beams is possible. Guardian Fall Protection is not responsible for any structural damages that
may occur.
When used as anchorage connector, MAXIMUM 1 connection per Stingray Anchor.
NEVER use Stingray Anchor simultaneously as independent
anchorage connector and as component of HLL system.
! WARNING
When used in HLL applications, 300’ MAXIMUM
system length. MAXIMUM 60’ between
consecutive Stingray Anchors; for complete
Stingray Anchor Systems longer than 60’,
intermediary Stingray Anchor(s) and at least
1 additional Absorbinator MUST be used.
While details about Absorbinator are provided
in this manual, the complete Absorbinator
instruction manual MUST be read and fully
understood prior to using Absorbinator in
combination with Stingray Anchor.
MAXIMUM 2 PFAS per complete Stingray Anchor System, unless the following conditions are met:
1. HLL Cable, with attached Absorbinator, must be terminated at a pair of Stingray Anchors. This
is considered 1 span.
2. In intended direction of HLL, and on non-utilized connection point of Stingray Anchor from
previous pair, attach another Absorbinator, then attach separate HLL Cable to Absorbinator to
continue Stingray Anchor System.
3. 2 PFAS may be used per EACH Absorbinator span within Stingray Anchor System up to a
MAXIMUM 6 PFAS in entire system.