Qualcraft Stingray Anchor - Manual (Page 17)

Shackle
Absorbinator
Turnbuckle
Thimble
Cable
Clamps
4. For all Absorbinators, attach Absorbinator to steel shackle, or to compatible carabiner, and
attach shackle/carabiner to Stingray Anchor connection point. If shackle is used, tighten bolt
until at least one thread is fully visible.
5. Attach turnbuckle to Absorbinator. Tighten bolt until at least one thread is fully visible.
6. Attach cable thimble on other end of turnbuckle. Tighten bolt until at least one thread is fully
visible.
7. Loop one end of HLL Cable around thimble. Pull cable through 5--1/4”. Secure cable with
MINIMUM 3 Cable Clamps (refer to Absorbinator instruction manual for complete Cable Clamp
installation instructions). 1) Apply first Cable Clamp one full Clamp length away from cable
termination. Use torque wrench to evenly tighten Clamp, alternating from one nut to the other,
until reaching torque of 45 foot-pounds; 2) Apply second Cable Clamp as close to thimble as
possible, and tighten in same manner; 3) Apply third Cable Clamp equally between previously
installed Cable Clamps, and tighten in same manner.
8. At second HLL Cable termination point, attach second cable thimble to Stingray Anchor
connection point.
9. Loop HLL Cable around second cable thimble, and attach minimum 3 Cable Clamps per
instructions specified in step #7.
G
ua
rd
ia
n
Fa
ll
Pr
ot
ec
tio
n
6
30
5
S.
2
31
st
S
t.
, K
en
t,
W
A
9
80
32
p
ho
ne
: (
80
0)
4
66
-6
38
5
f
ax
: (
80
0)
6
70
-7
89
2
w
w
w
.g
ua
rd
ia
nf
al
l.c
om
15