Ramsey Winch HDG-350 LEVER EQUIPPED - Manual (Page 7)

5
TROUBLE SHOOTING GUIDE
CONDITION POSSIBLE CAUSE CORRECTION
Clutch inopera
Ɵve 1. Dry or rusted shaŌ. 1. Clean and lubricate.
or binds up. 2. Bent yoke or linkage. 2. Replace yoke or sha Ō
assembly.
3. Clutch jaws are in contact. 3. See Techniques of
Opera
Ɵon
Oil leaks from 1. Seal damaged or worn. 1. Replace seal.
housing 2. Too much oil. 2. Drain excess oil. Refer to
Techniques of Opera
Ɵon.
3. Damaged gasket. 3. Replace gasket.
Winch runs 1. Hydraulic motor worn out. 1. Replace motor.
too slow 2. Low
Ňow rate. 2. Check Ňow rate. Refer to
Hydraulic Systems Ňow
chart, page 4.
Cable Birdnests 1. Drag brake disc worn. 1. Replace discs.
when clutch is
disengaged.
Hydraulic Ňuid 1. Hydraulic motor shaŌ seal 1. Replace seal.
leaks out hole in damaged.
motor adapter
INSTRUCTIONS FOR OVERHAUL OF HDG-350
DIS-ASSEMBLY
1. Drain oil from gear housing by
removing #40 plug from bottom of
gear housing. Remove plugs #38 &
#39 from top of gear housing.
Remove mounting angles from
winch by removing hardware shown.