Ramsey Winch HDG-350 LEVER EQUIPPED - Manual (Page 9)

7
6. Check for signs of wear on gear teeth. If
replacement of gear is necessary, replace
as follows:
a) Press gear #6 from shaft #14.
b) Examine shaft keys and keyways.
If distortion of keys and/or keyways is
evident, shaft and keys should be
replaced.
c) Use a soft hammer to gently tap keys
#36 into keyways. Press gear #6
over shaft and keys. Gear must be
centered over keys.
7. Remove seal #44 from back of #8 gear housing.
Press bushing #21 from gear housing. Press
new bushing and seal back into place.
8. Check drum bushings #20 for signs of wear.
Replace if necessary by pressing old
bushings from drum. Press new ones into
place.
9. Check clutch housing bushing #20 for wear. If
necessary, remove old bushing and press new
bushing into place. Apply grease to lube fittings
#37 to lubricate clutch shifter shaft.
10. Check cover bushing #20 for signs of wear. If
necessary remove old bushing and press
bushing into place.